How to tweak Smart Broadband

I will not be responsible for any damages or loss you may encounter by following this guide.
For any damaged canopy, call customersupport and have it replaced[(make sure you do not tell them anything about the canopy tweaking coz they would surely refused any replacement request)].

In order for you to tweak your connection, you must be able to access your canopy through html.
1. Go to Control Panel, select Network Connections, find your Smart Broadband connection (LAN or High-speed internet) and right click on it.

2. Click Properties, on the General tab, find the Internet Protocol (TCP/IP) and highlight it(usually at the bottom of the list). Click Properties.

3. Under the General tab, select Use the following IP address and enter the following data in their respective properties:

IP address: 169.254.3.3

Subnet mask: 255.255.0.0

Then click OK.

4. Open your browser (Internet Explorer, FireFox, Opera) and typed in this address on the address bar: 169.254.1.1

If you cannot access your canopy software after following these steps, then your canopy MS is probably blocked.

In the canopy page, go to the Configuration page and copy the attributes on the picture below.

 Save and Reboot.

After tweaking your canopy settings,

1. Go to Control Panel, select Network Connections, find your Smart Broadband connection (LAN or High-speed internet) and right click on it.

2. Click Properties, on the General tab, find the Internet Protocol (TCP/IP) and highlight it(usually at the bottom of the list). Click Properties.

3. Under the General tab, select obtain an IP address automatrically  and click OK. You should be seeing results after 2-3 days

(Let me know what you think… Post your comments here… TNX!)